Apple Xserve (Early 2008) DIY Procedure for Heat Ssink Instrukcja Użytkownika

 Xserve (Late 2006/Early 2008)073-1096 Rev. BProcessor Heat SinkReplacement InstructionsFollow the instructions in this document carefully. Failure t

Xserve (Late 2006/Early 2008) Processor Heat Sink Replacement Instructions 10Use the edge of the package that the alcohol wipe came in as a spatula t

Xserve (Late 2006/Early 2008) Processor Heat Sink Replacement Instructions 11Note: When installing the processor on the logic board, align the proces

Xserve (Late 2006/Early 2008) Processor Heat Sink Replacement Instructions 12Carefully seat the heat sink over the processor, aligning the four screw

Xserve (Late 2006/Early 2008) Processor Heat Sink Replacement Instructions 13Ensure the airow duct ts ush all over, and does not protrude above th

Xserve (Late 2006/Early 2008) Processor Heat Sink Replacement Instructions 14 Apple Inc.© 2006, 2008 Apple Inc. All rights reserved.Under the copyri

Xserve (Late 2006/Early 2008) Processor Heat Sink Replacement Instructions 2Warning: Always shut down the Xserve before opening it to avoid damaging

Xserve (Late 2006/Early 2008) Processor Heat Sink Replacement Instructions 3Opening the XserveLoosen the thumbscrews at the back of the top cover and

Xserve (Late 2006/Early 2008) Processor Heat Sink Replacement Instructions 4Caution: Try not to completely remove the screws from the airow duct. Ti

Xserve (Late 2006/Early 2008) Processor Heat Sink Replacement Instructions 5Loosen the four screws securing the heat sink in the order indicated belo

Xserve (Late 2006/Early 2008) Processor Heat Sink Replacement Instructions 6Caution: Whenever you handle the heat sink, handle it from the slotted si

Xserve (Late 2006/Early 2008) Processor Heat Sink Replacement Instructions 7Caution: Each heat sink is connected to the logic board by a small 2-pin

Xserve (Late 2006/Early 2008) Processor Heat Sink Replacement Instructions 8Installing the Replacement Processor Heat SinkNote: The thermal bond betw

Xserve (Late 2006/Early 2008) Processor Heat Sink Replacement Instructions 9Clean o any existing thermal grease on the top face of the processor usi