Apple Grappler Instrukcja Użytkownika Strona 1

6. Is there paper in the printer?7. Will your printer self-test” (see printer manual)?The above will confirm that all physical connections have been m

All Text is Printed in Italics (lIc Plus and IlGS)- If you are using the Grappler 9 Pin in parallel mode to print text docu-ments, set switch A to the

PARALLEL INTERFACE PIN ASSIGNMENTPins Signal Direction1 Strobe Out2 Data Bit 1 Out3 Data Bit 2

RADIO FREQUENCY INTERFERENCEThis equipment generates and uses radio frequency energy, and if not installed and used properly in strict accordance with

LIMITED WARRANTYEvery Grappler 9 Pin board is fully tested and checked for quality prior to shipment. It is warranted to be free from defects in mate

WARNINGSOrange Micro Inc. reserves all rights in the software incorporated in PROM or EPROM in the Grappler 9 Pin and in the Users Manual.

Grappler 9 PinParallel Printer Interface User’s Manual TABLE OF

GETTING STARTEDINTRODUCTIONIn the world of computers and printers, information can be sent or received in two forms: serial or parallel. Information t

3. With the power to all units off, plug the Grappler 9 Pinprinter connector into your parallel printer port. Refer to your printer users guide for th

In order to pave the way for error-free operation of the Grappler 9 pin, it is recommended that you take each of these steps one at a time.STEP 1: Get

for your particular printer.The GRAPPLER DIP switch is comprised of four small switch handles that can be selected to ON or OFF. To set the DIP switch

2. Parallel Mode. If your software application allows for selection of a specific parallel printer (not the lmageWriter), verify that switch handles B

Now hit the Return key five limes. Your printer should be printing the prompt character ']" each time you strike the Return key. If not, dou