Apple Logic Board Instrukcja Użytkownika

073-0665 Rev. D  Xserve Logic Board Replacement Instructions Follow the instructions in this sheet carefully. Failure to follow these instructions

Xserve Logic Board - 10 Power Supply 1. Release the locking latch on the power supply cable connector and disconnect the cable from the drive interc

Xserve Logic Board - 11 Logic Board 1. Release the thumb screw that secures the logic board to the chassis. (Figure 13) 2. Move the logic board for

Xserve Logic Board - 12 Installing the Replacement Logic Board 1. If the heatsink thermal pad on the underside of the replacement logic board has pr

Xserve Logic Board - 13 Power Supply 1. Reconnect the power supply to the logic board. 2. Tighten the thumb screw that secures the power supply to

Xserve Logic Board - 14 3. Reconnect the blower cable, if you disconnected it earlier. Heatsink and Processor, Version 1 1. Position the processor o

Xserve Logic Board - 15 6. To ensure the grease spreads evenly over the processor, lightly tighten the screws in the order indicated below. (FIgure

Xserve Logic Board - 16 Heatsink and Processor, Version 2 1. Insert the threaded end of one of the processor installation guides into the logic boar

Xserve Logic Board - 17 3. Carefully align the screw holes on the replacement heatsink and processor with the two guides, and lower the unit straigh

Xserve Logic Board - 18 5. Remove the two installation guides.6. Replace the three mounting screws and secure the processor and heatsink to the logi

Xserve Logic Board - 19 Battery Remove the battery insulator tab from the battery holder on the replacement logic board. (Figure 23)Figure 23Note:

Xserve Logic Board - 2 3. If the server is in the locked position (the yellow security LED on the front panel is on), use the Allen key that came wi

Xserve Logic Board - 20  Apple Computer, Inc. © 2003 Apple Computer, Inc. All rights reserved.This document is protected under U.S. Copyright Law

Xserve Logic Board - 3 8. Grasp the thumbscrews and slide the bottom housing forward part way to expose the two chassis levers. (Figure 2) 9. While

Xserve Logic Board - 4 Removing the Installed Logic Board Note: The replacement logic board does not include memory DIMMs or expansion cards. You m

Xserve Logic Board - 5 Dual-Slot Riser 1. Release the thumb screw that secures the riser’s cards to the server. (Figure 4) 2. If there are latches

Xserve Logic Board - 6 2. Pull the clip on the riser forward to release the riser from the logic board connector. (Figure 6) 3. Disconnect the rise

Xserve Logic Board - 7 3. Release the three captive screws that secure the heatsink. (Figure 8) 4. Lift the heatsink straight up and remove it from

Xserve Logic Board - 8 Heatsink and Processor, Version 2 1. Using a Phillips screwdriver, remove the three screws that mount the heatsink and proces

Xserve Logic Board - 9 ATA Controller Board 1. If necessary, disconnect the blower cable near the ATA controller board. (Figure 11) 2. Press in on