Apple Xserve (Early 2008) DIY Procedure for Rear ID Butt Instrukcja Użytkownika Pobierz pdf

 Xserve (Late 2006/Early 2008)

073-1111 Rev. B

Rear ID Button

Replacement Instructions

Follow the instructions in this document carefully. Failure to follow these instructions could

damage your equipment and void its warranty.

Online instructions are available at http://www.apple.com/support/diy/.

Working Safely Inside the Xserve

Always touch the Xserve enclosure to discharge static electricity before you touch any

components inside the Xserve. To avoid generating static electricity, do not walk around the

room until you have nished working inside the server and have replaced the cover. To minimize

the possibility of damage due to static discharge, wear an antistatic wrist strap while you work

inside the Xserve.

Warning: Always shut down the Xserve and disconnect the power cords before opening

it to avoid damaging its internal components or the components you are installing. Don’t

open the server while it is turned on. Even after you shut down the Xserve, its internal

components can be very hot. Let it cool before you open it.

Tools Required

The only tools required for this procedure are a Phillips #1 screwdriver and needlenose pliers.

Removing the Xserve from a Rack

Alert users that the server will be unavailable for a period of time. 1.

Shut down the Xserve (see the Xserve User’s Guide for help) and then wait to let the Xserve 2.

internal components cool.

Warning: Always shut down the Xserve before opening it to avoid damaging its internal

components or the components you want to install or remove. Don’t open the Xserve

or try to install or remove items inside while it is turned on. Even after you shut down

the Xserve, its internal components can be very hot. Let it cool down for 5 to 10 minutes

before you open it.

1 2 3 4 5

Podsumowanie treści

Strona 1 - Rear ID Button

 Xserve (Late 2006/Early 2008)073-1111 Rev. BRear ID ButtonReplacement InstructionsFollow the instructions in this document carefully. Failure to fol

Strona 2 - Opening the Xserve

Xserve (Late 2006/Early 2008) Rear ID Button Replacement Instructions 2Unplug all cables from the Xserve. 3. Note: If you have trouble releasing a ca

Strona 3 - Right PCI Riser Card

Xserve (Late 2006/Early 2008) Rear ID Button Replacement Instructions 3Removing the Installed Rear ID ButtonNote: Before you can remove the rear ID b

Strona 4

Xserve (Late 2006/Early 2008) Rear ID Button Replacement Instructions 4Using needlenose pliers, gently squeeze together the two clear plastic prongs

Strona 5 - Closing the Xserve

Xserve (Late 2006/Early 2008) Rear ID Button Replacement Instructions 5Closing the XserveReplace and secure the cover.1. Slide the Xserve back into t

Komentarze do niniejszej Instrukcji

Brak uwag

Apple Xserve (Early 2008) DIY Procedure for Rear ID Butt Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Oprogramowanie Apple Xserve (Early 2008) DIY Procedure for Rear ID Butt. Apple Xserve (Early 2008) DIY Procedure for Rear ID Button User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Apple Xserve (Early 2008) DIY Procedure for Rear ID Butt