Apple Xserve (Power Supply Replacement) Instrukcja Użytkownika Pobierz pdf (Strona 1)

073-0668 Rev. B



Xserve

Power Supply

Replacement Instructions

Follow the instructions in this sheet carefully. Failure to follow these instructions could

damage your equipment and void its warranty.

Note:

Online instructions covering customer-installable parts are available at

http://www.info.apple.com/installparts/.

Tools Required

No tools are required for this procedure. You may, however, ﬁnd a Phillips screwdriver

useful in releasing the thumbscrews at the front of the server.

Opening the Server

The server slides open from the front of the rack. The top cover remains in place in the

rack while the bottom housing (containing all internal components) should be placed on a

sturdy, ﬂat surface.

Note:

Two people are required to slide the server open: one to depress the chassis levers

and one to pull the bottom housing out of the rack.

1. Alert users that the server will be unavailable for a period of time.

2. Shut down the server.

Warning: To avoid damaging internal components or causing injury, always

shut down the server before opening it. After you shut down the server, internal

components can be very hot. Let the server cool down before continuing.

3. Write down the server’s serial number, which is located on the back panel. If it is

necessary to set up the server’s software after you replace the power supply, you will

be asked for the serial number at login.

1 2 3 4 5 6

Power Supply 1
Closing the Server 6

Podsumowanie treści

Strona 1 - Power Supply

073-0668 Rev. B  Xserve Power Supply Replacement Instructions Follow the instructions in this sheet carefully. Failure to follow these instruction

Strona 2

Xserve Power Supply - 2 4. If the hard drives are in the locked position (the yellow security LED on the front panel is on), use the Allen key that

Strona 3

Xserve Power Supply - 3 9. Grasp the thumbscrews and slide the bottom housing forward part way to expose the two chassis levers. (Figure 2) 10. Whi

Strona 4

Xserve Power Supply - 4 Removing the Installed Power Supply Warning: The power supply is a high-voltage component and should not be opened for any r

Strona 5

Xserve Power Supply - 5 3. Release the locking latch on the power supply cable connector and disconnect the cable from the drive interconnect board.

Strona 6 - Closing the Server

Xserve Power Supply - 6 Closing the Server 1. Carefully slide the bottom housing back into the rack.2. Tighten the front thumb screws to secure it.

Komentarze do niniejszej Instrukcji

Brak uwag

Apple Xserve (Power Supply Replacement) Instrukcja Użytkownika Strona 1

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Komputery Apple Xserve (Power Supply Replacement). Apple Xserve (Power Supply Replacement) User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Apple Xserve (Power Supply Replacement) Instrukcja Użytkownika Strona 1

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Komputery Apple Xserve (Power Supply Replacement). Apple Xserve (Power Supply Replacement) User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Komputery Apple Xserve (Power Supply Replacement)