Apple Processor Cage and Clips Przewodnik Instalacji Pobierz pdf (Strona 66)

3. Continue on to “Setting Up the Service Processor and Storage System” (page 70) to set up

the VSP with SmartStart over the public network. If you are not using SmartStart, see “Installing

HP 3PAR Storage Software When HP 3PAR SmartStart is Unavailable” (page 113) to manually

launch the setup wizards.

Option B: Non-DHCP Environment

To set the IP address of the VSP:

1. In the VMware vSphere Client window, select the Console tab, click anywhere on the screen,

and press Enter.

2. Log on as setupusr. Press Enter.

A password is not required to configure the network settings.

3. Enter the service processor IP address and press Enter.

4. Enter the Netmask address and press Enter.

5. Enter the default gateway address and press Enter.

6. Enter Y to configure the network and press Enter.

7. Review the configuration confirmation and record the VSP IP address for reference during

subsequent setup procedures with HP 3PAR SmartStart or the SP Setup Wizard.

Figure 44 Network Setup Confirmation

8. Press Enter to exit.

9. Press Ctrl-Alt to release the cursor.

10. Continue on to “Setting Up the Service Processor and Storage System” (page 70) to set up

the VSP with SmartStart over the public network. If you are not using SmartStart, see “Installing

HP 3PAR Storage Software When HP 3PAR SmartStart is Unavailable” (page 113).

NOTE: This network configuration is temporary. If the VSP is rebooted, you will need to

repeat this procedure before continuing to the Service Processor configuration.

66 Initializing the Service Processor

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 116 117

Brak uwag

Apple Processor Cage and Clips Przewodnik Instalacji Strona 66