Apple Xserve (Early 2008) DIY Procedure for Hard Supply Instrukcja Użytkownika Strona 1

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Oprogramowanie Apple Xserve (Early 2008) DIY Procedure for Hard Supply. Apple Xserve (Early 2008) DIY Procedure for Hard Supply User Manual Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 2
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
 Xserve (Late 2006/Early 2008)
073-1085 Rev. B
Power Supply/Power Supply Blank
Replacement Instructions
Follow the instructions in this document carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Online instructions are available at http://www.apple.com/support/diy/.
Note: You can replace or install a power supply from the back panel without removing the
Xserve from the rack. If the Xserve has two power supplies, they are hot-swappable; the Xserve
will continue to operate using only one supply while the second is removed.
Tools Required
No tools are required for this procedure.
Removing the Installed Power Supply/Power Supply Blank
Unplug the power cord from the power supply you are removing.1.
Pull the handle to release the power supply or power supply blank and slide it out of the bay.2.
Pull the handle to unlatch the
power supply and remove it.
Przeglądanie stron 0
1 2

Podsumowanie treści

Strona 1 - Replacement Instructions

 Xserve (Late 2006/Early 2008)073-1085 Rev. BPower Supply/Power Supply BlankReplacement InstructionsFollow the instructions in this document carefull

Strona 2 - Slide the power supply in and

Xserve (Late 2006/Early 2008) Power Supply/Power Supply Blank Replacement Instructions 2Installing the Replacement Power Supply/Power Supply BlankPre

Komentarze do niniejszej Instrukcji

Brak uwag