Apple Xserve (Logic Board with Processor/Heatsink Replac Instrukcja Użytkownika

073-0711 Rev. B  Xserve Logic Board with Processor/Heatsink Replacement Instructions Follow the instructions in this sheet carefully. Failure to f

Xserve Logic Board with Processor/Heatsink - 10 2. Install the replacement logic board in the bottom housing, making sure the board fits over the fou

Xserve Logic Board with Processor/Heatsink - 11 8. Reinstall the two ATA controller clips. Note: When replacing the ATA controller board clips, ori

Xserve Logic Board with Processor/Heatsink - 12 12. Remove the battery insulator tab from the battery holder on the replacement logic board. (Figur

Xserve Logic Board with Processor/Heatsink - 13  Apple Computer, Inc. © 2002 Apple Computer, Inc. All rights reserved.This document is protected

Xserve Logic Board with Processor/Heatsink - 2 3. If the server is in the locked position (the yellow security LED on the front panel is on), use th

Xserve Logic Board with Processor/Heatsink - 3 8. Grasp the thumbscrews and slide the bottom housing forward part way to expose the two chassis leve

Xserve Logic Board with Processor/Heatsink - 4 Removing the Installed Logic Board Note: The replacement logic board does not include memory DIMMs o

Xserve Logic Board with Processor/Heatsink - 5 Dual-Slot Riser 1. Release the thumb screw that secures the card to the back of the server. (Figure

Xserve Logic Board with Processor/Heatsink - 6 2. Pull the clip on the riser forward to release the riser from the logic board connector. (Figure 6

Xserve Logic Board with Processor/Heatsink - 7 ATA Controller Board 1. Disconnect the blower cable nearest the ATA controller board. (Figure 8) 2.

Xserve Logic Board with Processor/Heatsink - 8 Power Supply 1. Release the locking latch on the power supply cable connector and disconnect the cabl

Xserve Logic Board with Processor/Heatsink - 9 Logic Board 1. Release the thumb screw that secures the logic board to the chassis. (Figure 10) 2. M