Apple Xserve (Early 2008) DIY Procedure for Enclosure Instrukcja Użytkownika Pobierz pdf (Strona 144)

Xserve (Late 2006/Early 2008) Rear ID Tab Replacement Instructions 3

Opening the Xserve

Loosen the thumbscrews at the back of the top cover and slide the cover back and up to remove

it. If you have diculty removing the cover, check the enclosure lock on the front panel.

Warning: Even after you shut down the Xserve, its internal components can be very hot. Let

it cool before you open it.

Important: To minimize the possibility of damage to Xserve components due to static discharge,

wear an antistatic wrist strap, if possible, while you work inside the Xserve.

Unscrew the two

captive thumbscrews.

Slide the cover back and lift it off.

Removing the Installed Rear ID Tab

Before removing the installed rear ID tab, remove the following parts:

Both power supplies•

PCI riser cards and any expansion cards in both slots (if installed)•

Airow duct•

Fan array•

Backplane-to-logic board I/O cable•

Both processor heat sinks•

Logic board•

Power Supplies

Pull the handle to release the rst power supply and slide it out of the bay. 1.

Pull the handle to unlatch the

power supply and remove it.

Repeat for the second power supply, if installed.2.

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 168 169

Brak uwag

Apple Xserve (Early 2008) DIY Procedure for Enclosure Instrukcja Użytkownika Strona 144