Apple Xserve (Early 2008) DIY Procedure for Enclosure Instrukcja Użytkownika Pobierz pdf (Strona 99)

Xserve (Late 2006/Early 2008) Processor Heat Sink Replacement Instructions 3

Opening the Xserve

Loosen the thumbscrews at the back of the top cover and slide the cover back and up to remove

it. If you have diculty removing the cover, check the enclosure lock on the front panel.

Warning: Even after you shut down the Xserve, its internal components can be very hot. Let

it cool before you open it.

Important: To minimize the possibility of damage to Xserve components due to static discharge,

wear an antistatic wrist strap, if possible, while you work inside the Xserve.

Unscrew the two

captive thumbscrews.

Slide the cover back and lift it off.

Removing the Installed Processor Heat Sink

Note: Before you can remove a processor heat sink, you must remove the airow duct.

Airow Duct

Loosen the ve Phillips screws that fasten the airow duct to the fan array.1.

Pull up on either side of the airow duct, and lift it straight up and out of the Xserve. 2.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 168 169

Brak uwag

Apple Xserve (Early 2008) DIY Procedure for Enclosure Instrukcja Użytkownika Strona 99