Apple Xserve (Early 2008) DIY Procedure for Enclosure Instrukcja Użytkownika Pobierz pdf (Strona 166)

Xserve (Late 2006/Early 2008) Rear ID Tab Replacement Instructions 25

Connect the cable to the logic board rst. Then press the adhesive section of the cable onto 2.

the enclosure before connecting the other end of the cable to the backplane.

Caution: Make sure the cable is fully seated.

Replacing the Fan Array

Align the power connector on the fan array with its connector on the power distribution 1.

board and lower the array into the enclosure. Push down on the fan array power connector

to make sure it is fully seated.

Tighten the screws at the ends of the array. Make sure the large front panel board cable runs 2.

above the power connector but below the tab on the top of the power supply.

1 2 ... 161 162 163 164 165 166 167 168 169

Brak uwag

Apple Xserve (Early 2008) DIY Procedure for Enclosure Instrukcja Użytkownika Strona 166